Standard Unit Pricing
For more information contact:
Brian Tacke 540-374-1000 x118btacke@syntronics.net
Miniature S-Band Telemetry Transmitters
Syntronics’ family of truly miniature S-Band Telemetry Transmitters range from 0.33 watts RF output power to 2 watts RF output power. These tiny S-Band Telemetry Transmitters allow you to integrate telemetry into even the smallest system. Also, the small size and high power of these transmitters allow telemetry for larger systems to be unobtrusive, requiring minimal volume, as well as being low in cost. The smallest Syntronics Telemetry Transmitter is on a single circuit board only 0.9 inches in diameter, yet has an RF output of 0.33 watts and runs on only 3.3 volts. Our Standard S-Band Telemetry Transmitter is mechanically identical to the M/A-COM HSTSS transmitter, but with better performance, lower price, and, more importantly, is always available in six weeks or less.
The transmitter frequency is specified at the time of the order and can be any where from 2.205GHz to 2.295GHz in 500kHz increments.
This family of S-Band Telemetry Transmitters have been extensively tested by our many customers and have been proven to be reliable in the harsh gun launch environment. In fact, they are specified to survive a gun launch environment of up to 20,000Gs when properly mounted.
All of the miniature S-Band Telemetry Transmitter configurations are available with a three week typical, six week maximum, lead time from the receipt of order.
Not exactly what you need? Requests for custom configurations or complete Telemetry Solutions are welcome.
Common Specifications
- Single Circuit Board Design
- Gun Launch Shock: up to 20,000Gs*
Temperature Range:
- Operating: -40ºC to +85ºC
- Storage: -40ºC to +125ºC
Input:
- Input Impedance: 10K ohms
- 3.3V Logic Level, 500 Kbits/sec to 2 Mbits/sec*
RF Output:
- Vertical MMCX Jack
- Load Impedance: 50 ohms
- VSWR: 2
- Carrier Frequency: S-Band, 2.205GHz to 2.295GHz*
- Stability: Better than 0.002%
- Carrier Frequency Accuracy: ±50 ppm all causes
*User specified at the time of order
S-Band Transmitter Models
Mechanical:
- One 1.125” Square Circuit Board with four #4” mounting holes on a 0.9” square
- 3.3VDC @ 500mA
- 0.33 watts RF
- Solder Pads for Power, Ground, and Modulation Input
Micro S-Band Transmitter (INST-11B) ..................................................$945
Mechanical:
- One 0.8” Diameter Round Circuit Board, No Mounting Holes
- 3.3VDC @ 500mA
- 0.33 watts RF
- 20 Pin Hirose DF12-20DS-0.5V(80)
High Power S-Band Transmitter (INST-11C) ..................................................$1,600
Mechanical:
- One 1.8” Diameter Round Circuit Board
- 6.0DC @ 750mA
- 1 watt RF (30dBm)
- Solder Pads for Power, Ground, and Modulation Input
Adjustable High Power S-Band Transmitter (INST-11D) ..................................................$3,000
Mechanical:
- One 1.8” Diameter Round Circuit Board
- 5 VDC @ 1.3A (2W out)
- 1 to 2 watts RF, Jumper Selectable
- Solder Pads for Power, Ground, and Modulation Input
